Honeywell XYR 400E User Manual page 29

Network Settings Webpage Fields
Operating Mode
Device Mode
FTP Enabled
MAC Address
Gateway IP Address
Ethernet IP Address
Ethernet IP Subnet
Mask
Wireless IP Address
Wireless IP Subnet
Mask
System Address
(SSID)
Desired BSSID
Radio Encryption
29
Used to select Access Point (Infrastructure), Client (Infrastructure),
IBSS (Ad-Hoc), or MONITOR mode.
By default this is set to Client.
Used to select Bridge or Router mode.
By default this is set to Bridge.
This enables access to volatile memory storage on the XYR 400E.
By default this is disabled.
This is the unique hardware address of the XYR 400E, assigned in
the Factory. For the majority of systems, this item should not be
changed.
If the device is to be connected to equipment that will only
communicate with a set MAC Address, the XYR 400E may clone
that MAC address.
This is only required if the wired LAN has a Gateway unit which
connects to devices beyond the LAN - for example, Internet
access. If there is no Gateway on the LAN, set to the same address
as the Access Point - that is, the "Ethernet IP Address" below.
The IP address of the XYR 400E on its wired Ethernet port. This
should be set to the IP address you require.
The IP network mask of the XYR 400E on its Ethernet port. This
should be set to the IP address you require.
The IP address of the XYR 400E on the wireless port. If the unit is
configured as a bridge this address will be the same as the Ethernet
IP address. If configured as a router, the IP address must be different
from the Ethernet IP Address - it must be consistent with the LAN
it is connecting to on the wired side.
The network mask of the XYR 400E on the radio port. If configured
as a Bridge, this must be the same as the Ethernet IP Subnet Mask.
A XYR 400E network comprises modules with the same "system
address". Only modules with the same system address will
communicate with each other. The system address is a text string 1
to 31 characters in length. Select a text string which identifies for
your system.
To force a client/station to always connect to the same Access Point
enter the MAC address of that Access Point in the Desired BSSID
field (Note that the SSID of the Access Point must also match the
configured SSID of the client).
Select "None", "WEP (64-bit)", "WEP (128-bit)",
XYR400E Ethernet Modem Version 1
5/1/08