NEC Univerge SV8100 Features And Specifications Manual page 1322

Issue 1.0
3. Dial 616 and the VRS password.
4. Dial the function you want.
7 = Record
5 = Listen
3 = Erase
5. Dial the message number (01~48), record the message and press
If you dialed 7 to record, you can dial # to listen to the message you just recorded.
If you dialed 5 to listen, you can dial 5 and the message number to hear it again or if you want to Record, listen to
or erase another message, go back to step 4.
General Message
To listen to the General Message:
Multiline Terminal Only
Your Message Waiting LED flashes when there is a new General Message. A voice message periodically
reminds you.
1. Do not lift the handset or press Speaker.
2. Dial 4 (General).
- OR -
1. Lift the handset and dial 611.
You hear the General Message.
Normally, your MW LED goes out. If it continues to flash, you have unanswered Message Waiting requests or new
messages in your Voice Mail mailbox.
To record, listen to or erase the General Message:
1. Press Speaker or lift the handset.
- OR -
At single line telephone, lift the handset.
2. Dial 612.
3. Dial the function you want.
7 = Record
5 = Listen
3 = Erase
If you dialed 7 to record, press # to end the recording.
If you dialed 5 to listen, you can dial 5 to listen to the message again.
To Record the General Message again, go back to step 1.
If you dialed 3 to erase the General Message, you must go to step 4 (hang up). To cancel without erasing on a
multiline terminal, press HOLD instead and go back to step 1.
4. Hang up when you are done.
2 - 1298
UNIVERGE SV8100
to end recording.
#
Voice Response System (VRS)