Setting Up A Modem Serial Device; Table 8-3 System Tab Default Values - Honeywell Rapid Eye Administrator's Manual

Configuring Other Hardware

Setting Up a Modem Serial Device

152
Table 8-3 System Tab Default Values (cont'd)
Box Group Name of Box/Button
Subnet Mask
Gateway
MAC Address
Throughput High/Low
Signal Format NTSC / PAL
System Monitor Enable Status Pulse
Monitor Alarm Reporting
Max Network Data Regulate Data Rate
Send no more than [...]
kilobits per second
Local Monitoring Enable/Disable
a
Factory settings to identify the unit software and hardware.
b
Unavailable when DHCP is enabled. On networks that are not DHCP-enabled, the
DHCP default times out and is set to off.
c
Unavailable while Regulate Data Rate is not selected.
A dial-up connection is optional. Internal modems in Multi-Media units can remain unused.
Modem Settings
Modems are set up using the Serial Devices tab. The Serial Devices tab shows an Internal
Port that either lists a modem or nothing at all. If the Internal Port holds a modem, the
modem cannot be deleted. The internal port cannot receive devices from the New devices
or the Unassigned devices groups.
Caution Changing modem values in the next step can make the unit unavailable for
dial-up connection. If you are unsure, see your Multi SA.
Default
b
255.255.0.0
b
172.25.100.4
a
N/A ; stored on unit, for DHCP use
Low
NTSC
Off; see
Off
Off
32
c
Enable
System Monitor, page 148