Figure 3-7 Connection Settings For Nat Use Of An Internet Router; Table 3-1 Router Mappings For Nat Operation Of Rapid Eye Units - Honeywell Rapid Eye Administrator's Manual

PC running
Admin and View
Assign the router's
outside IP to the IP
Address of the
connection.
Router:
a
Outside IP
Use the router IP in the
connection's IP Address
Use the router IP in the
connection's IP Address
a
The values for IP addresses and ports depend on system administrator of the remote LAN.
b
All Rapid Eye units have the same port values, and these cannot be changed.
c
Each unit needs a unique IP Address.
d
The Rapid Eye Multi Admin may need to indicate to the system administrator of the remote LAN that the
Maintenance and FTP values are increments of the Session value, in a connection. See
Document 800-02953V4 Rev A
03/10
6. You have the option of indicating that the connection is to a router, rather than a unit,
by entering the Connection Name.
7. Click Save and Close. For a report, see
Figure 3-7 Connection Settings for NAT Use of an Internet Router
WAN
Table 3-1 Router Mappings for NAT Operation of Rapid Eye Units
Router:
a
Source Ports
for Rapid Eye unit #1
Set to Session value, in
the connection, 49,100
Set to Maintenance
value, 49,101
d
Set to FTP value,
49,102
for Rapid Eye unit #2
Set to Session value, in
the connection, 49,200
Set to Maintenance
value, 49,201
d
Set to FTP value,
49,202
Rapid Eye Multi-Media DVR System Administrator Guide
Connection Report
Use the router's inside
IP for the Gateway of
each unit.
Values for the
routing map,
in the router,
for unit #2.
Destination Ports
b
(constant)
on Rapid Eye unit #1
-> Use the constant value
a
for Rapid Eye: 10,000
d
-> 10,001
-> 21
on Rapid Eye unit #2
-> Map to Rapid Eye
a
constant value: 10,000
d
-> 10,001
-> 21
on page 56.
READY
ALARM
HDD
TM
Rapid Eye
unit #1
READY
AL ARM
HDD
TM
Rapid Eye
unit #2
a
Rapid Eye Unit IP
c
192.168.101.11
192.168.101.11
192.168.101.11
192.168.101.12
c
192.168.101.12
192.168.101.12
Figure 3-7.
47