Draytek Vigor2830 Series User Manual page 73

DNS Server IP Address
After finishing all the settings here, please click OK to activate them.
D e t a i l s P a g e f o r P
D e t a i l s P a g e f o r P
To use PPTP/L2TP as the accessing protocol of the internet, please click the PPTP/L2TP tab.
The following web page will be shown.
Detailed explanation is shown below:
Item
PPTP/L2TP
ISP Access Setup
Specify a MAC Address: Some Cable service providers
specify a specific MAC address for access authentication.
In such cases you need to click the Specify a MAC
Address and enter the MAC address in the MAC Address
field.
Type in the primary IP address for the router if you want to
use Static IP mode. If necessary, type in secondary IP
address for necessity in the future.
P T P / L 2 T P i n W A N
P T P / L 2 T P i n W A N
Description
Enable PPTP- Click this radio button to enable a PPTP
client to establish a tunnel to a DSL modem on the WAN
interface.
Enable L2TP - Click this radio button to enable a L2TP
client to establish a tunnel to a DSL modem on the WAN
interface.
Disable – Click this radio button to close the connection
through PPTP or L2TP.
Server Address - Specify the IP address of the PPTP/L2TP
server if you enable PPTP/L2TP client mode.
Specify Gateway IP Address – Specify the gateway IP
address for DHCP server.
Username -Type in the username provided by ISP in this
63
2
2
Vigor2830 Series User's Guide