Draytek Vigor2830 Series User Manual page 31

4. Click Finish. A page of Quick Start Wizard Setup OK!!! will appear. Then, the system
status of this protocol will be shown.
5. Now, you can enjoy surfing on the Internet.
1 4 8 3 B r i d g e d I P / 1
1 4 8 3 B r i d g e d I P / 1
1. Choose WAN1 as WAN Interface and click the Next button; you will get the following
page.
Available settings are explained as follows:
Item
VPI
VCI
Protocol /
Encapsulation
Fixed IP
IP Address
Subnet Mask
Primary DNS
Secondary DNS
Back
Next
4 8 3 R o u t e d I P
4 8 3 R o u t e d I P
Description
Type in the value provided by ISP.
Auto detect – Click this button to have the VPI and VCI to
be detected by the system automatically
Type in the value provided by ISP.
There are several modes offered for you to choose for
WAN1 interface.
Choose 1483 Bridged IP /1483 Routed IP as the protocol.
Click Yes to enable Fixed IP feature.
Type the IP address if Fixed IP is enabled.
Type the subnet mask.
Type in the primary IP address for the router.
Type in secondary IP address for necessity in the future.
Click it to return to previous setting page.
Click it to get into the next setting page.
21
Vigor2830 Series User's Guide