Fault Relay Setup
Document 800-02607V3 Rev A
11/09
Figure 5-6
System Tab Options for Monitoring the DVRs
Enable Status Pulse.
Enables the FAULT RELAY to trigger.
Monitor Alarm Reporting. Interruptions in reporting of alarms, greater than 15 minutes,
trigger the fault relay. The monitoring is designed to report alarms that have not reached
their designated alarm station, because that alarm station was unavailable.
1.
Using View software, start a Maintenance session.
2.
On the System tab, set the FAULT RELAY to trigger by selecting either Enable Status
Pulse, Monitor Alarm Reporting, or both (see
3.
On the Events tab, click the Outputs sub tab.
4.
The options for Output 6 have been greyed out (see
of changing the name of the output in the box.
5.
You have the option of ending the maintenance session.
Rapid Eye™ Multi-Media DVR Installation Guide
Figure
5-6).
Figure
5-7). You have the option
61