Beeping From The Dvr When An Alarm Is Triggered; Upgrading The Software Of A Dvr Onsite - Honeywell Rapid Eye Installation Manual

Beeping from the DVR When an Alarm is Triggered

Upgrading the Software of a DVR Onsite

Document 800-02607V3 Rev A
11/09
When using LocalView on a DVR without Honeywell Video Analytics, you may set the DVR
to produce a beeping noise when alarms are triggered.
1. Using LocalView, on the user menu, click Preferences.
2. On the Unit tab, select Beep on Alarms.
3. Click OK.
Onsite, you can upgrade a Multi-Media DVR equipped with a DVD drive, using the Upgrade
CD.
1. Remove the front cover of the Multi-Media DVR. If the cover is locked, use the key
supplied with the DVR.
2. Open the DVD drive.
3. Place the CD identified as UPGRADE into the tray.
4. Shut the DVD tray.
5. While the CD-ROM remains in the DVR, power-down the DVR.
6. Power-up the DVR.
7. Check the blue LCD. As the DVR starts up, a set of messages appear:
Honeywell Startup Shell
*Do Not Restart* Upgrading Unit
Upgrade Complete. Restarting Unit
Honeywell Startup Shell
8. The final message that appears depends on the upgrade and the DVR hardware.
When the software version is shown on the second line, the DVR is operational. The
DVD drive tray opens automatically.
9. Remove the CD and shut the DVD drive tray.
10. Replace the front cover on the DVR.
Rapid Eye™ Multi-Media DVR Installation Guide
39