Cisco BWX360 WiMAX User Manual page 44

Checking the connection to the Cisco BWX360 WiMAX Outdoor Modem
The PC now sends some test packets via this connection and checks whether the con-
nection partner responds. The connection partner may respond in the following ways:
Reply from the IP address of your Cisco BWX360 WiMAX Outdoor Modem; sta-
tistics about the connection are presented. If you receive these statistics, the con-
nection to the device is OK.
The request exceeds the time limit; it was not possible either to send or receive
any packets. There is no physical connection between the PC and your
Cisco BWX360 WiMAX Outdoor Modem. Check the following points:
– Are the Ethernet cables both between the Cisco BWX360 WiMAX Outdoor
Modem and the indoor unit as well as between the indoor unit and the PC prop-
erly connected?
The OUT and IN LEDs on the indoor unit must light up (see page 9).
– Has TCP/IP been properly configured on your PC?
If the Cisco BWX360 WiMAX Outdoor Modem has the IP address 192.168.2.1,
your PC's IP address must be between 192.168.2.2 and 192.168.2.254. The
subnet mask must be 255.255.255.0.
To find out the IP address of your PC, enter ipconfig in the command prompt.
If the Cisco BWX360 WiMAX Outdoor Modem has not responded successfully to the
ping command, you need to adjust the network settings on the PC. To find out how to
do this, please read the document "Configuring the local area network" on the product
CD.
If the Cisco BWX360 WiMAX Outdoor Modem has responded successfully to the ping
command, the network is configured correctly. If it is not possible to access the config-
uration program of your Cisco BWX360 WiMAX Outdoor Modem, check and change
the settings in your Web browser. To find out how to do this, please read the next chap-
ter.
44