Switching On The Devices - Cisco BWX360 WiMAX User Manual

Wall mounting (optional)

Switching on the devices

Only use the Cisco BWX360 WiMAX Outdoor Modem with the supplied
mains cable.
Refernece number: C39280-Z4-C584
Manufacturer: PhiHong
Type: POE30U-560(G)-S
Input: 100-240V, 0.95A AC
Output: 56V, 0,55A DC
Connect the power lead to the indoor unit.
Connect the power lead of the indoor unit to the mains power supply. The outdoor
modem is powered via the Ethernet cable and does not require its own mains con-
nection.
The system starts booting and performs a self-test.
After the self-test, the Cisco BWX360 WiMAX Outdoor Modem continually attempts
to register with a base station. Registration with the base station may be successful
immediately; otherwise, registration will take place when your Cisco BWX360
WiMAX Outdoor Modem is being configured.
Check the LEDs during startup:
LEDs during startup:
– The ON power supply LED lights up green, and the Cisco BWX360 WiMAX Out-
door Modem starts a self-test.
– The FAULT LED (red) and the CONNECT LED (green) light up for approximately
1 second and then go out. If the connection to the outdoor modem is then found
to be free from errors, the CONNECT LED is continuously lit up green. If an error
occurs, the FAULT and CONNECT LEDs start to flash alternately at regular inter-
vals.
14