Honeywell HEGS5000 User Manual page 48

5.2.13.1 Programming/Editing/Deleting Privacy Zones, Sony Camera, Continued
12. Press + or – until the character for the desired action is displayed on the LCD and
then press Character Select (
To save Privacy coordinates, press + or – until S is displayed on the LCD and
press Character Select (
coordinates.
a. Using the joystick, move the PTZ so the lower left corner of the privacy zone is
b. Using the joystick, move the PTZ so the upper right corner of the privacy zone is
The privacy zone is programmed for all points between the selected coordinates as
shown in the above diagram.
13. Repeat steps 9-12 to continue programming privacy zones or press Clear/Manual to
return to manual operation.
14. Press Dome Menu (
Rev. 1.01
ABC
Bottom tilt
Left pan
on the lower left corner of the monitor, and then press Enter (
on the upper right corner of the monitor, and then press Enter (
If the upper right tilt position is below the lower left tilt position, the message
"Illegal Tilt Direction" is displayed. Readjust the tilt position until the message
disappears or press Clear/Manual to cancel the operation and return to manual
operation.
1. ___
) to exit the Dome Menu.
3. ___
).
ABC
). Refer to the diagram below for programming
Right pan
Top tilt
38
).
).
900.0800
19-Jun-06