Section 3: Modes Of Operation; Modes Of Operation; Mode Configuration - Honeywell HEGS5000 User Manual

3.1

MODES OF OPERATION

There are two modes of operation when using the HEGS5000 as a standalone controller:
1. HEGS5000 = Standalone = PTZ control (KD6/HD6 and KDZ series) only. Note:
KDZ series domes have been discontinued.
2. HEGS5001 = MUX Mode = MUX/VCR control capability and PTZ control
There is a third mode of operation that is only for use with the HSX3208L Matrix Video
Switcher.
3. HEGS5002 = System = HSX3208L Switcher. Refer to the HSX3208L Switcher User
Manual for setup and operation of the HEGS5000 in System mode.
The default configuration is Standalone mode (PTZ control only). To change the
configuration, refer to Section 3.2
3.2

MODE CONFIGURATION

To configure the HEGS5000 mode of operation, perform the following steps.
1. Power-up the HEGS5000. The following messages are displayed on the LCD
display.
2. Before the unit counts down to 0, press 1. The LCD displays:
Note: The current configuration is displayed with ** on both sides as shown above.
Rev. 1.01
SECTION 3:
MODES OF OPERATION
Boot Mngr MMDDYY
519685-1980 A
Booting in 5s
< Run Bank >
** Standalone **
9
900.0800
19-Jun-06