Default Password; Default User Defined Settings; Lcd Display; Figure 4. Lcd - Honeywell HEGS5000 User Manual

3.3.1 Default Password

Master Default Password is 1994.
Operator Default Password is 1111.
Master mode has access to all menus. Operator mode allows access to all menus
except those in which changes to system setup are involved. The table below shows
which menus and functions are available for each mode.
Save PreShot - KD6/HD6 domes
Recall PreShot on KD6/HD6 domes
Programming a VectorScan - KD6/HD6 domes
Running a programmed VectorScan – KD6/HD6
dome
Programming a tour menu – KD6/HD6 dome
Running a tour – KD6/HD6 dome
NightShot On/Off –KD6/HD6
Auto iris on/off – KD6/HD6
Programming a sector – KD6/HD6
Programming a privacy zone – KD6/HD6
Access to the KD6/HD6 dome setup menu
Access to the System Setup Menu
Access to the multiplexer setup menu

3.3.2 Default User Defined Settings

To return the controller to the user-defined default settings, perform the following steps.
1. Power the unit down and back up.
2. When the LCD display shows the controller is Booting Run Menu key during the 5-
second booting process.

3.3.3 LCD Display

In the above display, the HEGS5000 is configured for MUX mode of operation. Spot01
is the Spot Monitor and Multiplexer the controller is currently controlling. This will
change if you have more than one multiplexer in your system. Spot 01 is the spot
monitor for multiplexer one; Spot 02 is the spot monitor for multiplexer two, etc. Refer to
section 6 for MUX operation.
Cam001 is the camera currently being controlled.
If the controller is configured for Standalone mode of operation; the Spot monitor is not
displayed.
Rev. 1.01
Description
<Spot01 Cam001>

Figure 4. LCD

11
Operator Master
1-10 Only Yes
Yes Yes
No Yes
Yes Yes
No Yes
Yes Yes
Yes Yes
Yes Yes
No Yes
No Yes
No Yes
No Yes
No Yes
900.0800
19-Jun-06