Honeywell HEGS5000 User Manual page 26

4.3 MENUS, CONTINUED
Menu Name
KDZ Setup
Serial No.
KD6-Z Addr
Set Address
Note: The above setup menu is simply a tool to allow the address of the KDZ dome to be
programmed from the controller. This information is not stored in the controller.
The address of each KDZ dome can be set one after each other without having to
exit this menu. Refer to the KDZ User Manual for detailed information on
programming and controlling a KDZ camera.
Menu Name
Passwords
Master
Operator
Menu Name
Outputs
Switch Dev
Address
Rev. 1.01
KDZ SETUP
Menu
Number
4.0 Used to program the address of any KDZ connected to
the HEGS5000. Press Enter (
4.1 Using the number keys, enter the serial number of the
KDZ dome. Press Enter (
supplied with the dome and is printed on the dome.
4.2 Enter the required address of the dome using the
number keys or
4.3
Press Enter (
the serial number and address to reprogram the KD6-Z
dome. Press Clear/Manual (
Passwords
Menu
Number
5.0
Press Enter (
5.1 Enter a new 4-digit master password. Once the digits
are entered, the password is reset.
5.2 Enter a new 4-digit operator password. Once the
digits are entered, the password is reset. Press
Clear/Manual (
Outputs
Menu
Number
6.0 An additional mutiplexer can be used to combine the
monitor outputs of multiple multiplexers to one monitor.
Press Enter (
6.1
Switch Device – use the
type of multiplexer used to combine the monitor
outputs.
Press Clear/Manual (
6.2 Enter the address of the output using the number keys
+
or the and
16
Description
) to access this menu.
). The serial number is
+ –
and keys. Press Enter (
) to confirm the information and send
) to exit this menu.
Description
) to access this menu.
) to exit this menu.
Description
) to access this menu.
+ –
and keys to select the
) to exit this menu.
–
keys (001 to 255).
).
900.0800
19-Jun-06