Honeywell HEGS5000 User Manual page 45

5.2.12 Programming Sector IDs, continued
8. Enter the Sector title (up to 24 characters)
a. Press the + or – key until the desired character is displayed on the LCD screen,
b. Continue selecting characters and press Character Select (
c. Press Enter (
9. Press + or – until the character for the desired action is displayed on the LCD and
then press Character Select (
To save Sector coordinates, press + or – until S is displayed on the LCD and press
Character Select (
coordinates.
a. Using the joystick, move the PTZ so the lower left corner of the sector is
Rev. 1.01
and then press Character Select (
the KD6/HD6.
desired title is displayed on the monitor.
).
The following options are displayed on the monitor:
E to Edit Sector
D to Delete Sector
S to Save Sector Coord.
N to Save Name only
). Refer to the diagram below for programming
ABC
Bottom tilt
Left pan
centered on the monitor, then press Enter (
). The controller sends the character to
ABC
Press + or – key until E is displayed on LCD and
press Char Select. Repeat step 8.
Press + or – key until D is displayed on LCD and
press Char Select. The Sector # entered in step
6 is deleted.
Press + or – until S is displayed on LCD and
press Char Select. Follow instructions in step 9.
Press + or – key until N is displayed on LCD and
press Char Select. This option is used for
renaming Sector IDs. The title only entered in
step 8 is saved for the Sector # entered. The
current sector coordinates are not changed.
).
ABC
Right pan
Top tilt
35
) until the
ABC
).
900.0800
19-Jun-06