Figure 3-65 Motion Detection Actions 1 Screen - Honeywell HRXD9 User Manual

Configuration
10. Highlight the box beside Daytime and press
11. Highlight the Actions 1 and Actions 2 tabs and the Motion Detection Actions 1
12. Highlight the box under the Record heading and press
13. Highlight the box under the Alarm-Out heading and press
Document 900.0856 Rev 3.00
11/07
buttons to set the Daytime range. The DVR will consider the remaining time range
as the Nighttime.
(Figure 3-65) and Actions 2
Figure 3-65
The DVR can be set to react to motion detection differently for each camera. Each
camera can be associated with another camera, trigger an Alarm-Out connector,
sound the DVR's internal buzzer, notify a number of different devices, move PTZ
cameras to preset positions, and/or display a camera on a SPOT monitor.
Note You can associate multiple cameras with a camera that detects
motion.
appears. You can associate as many cameras with that camera as you wish. If the
DVR detects motion on the selected camera, it starts recording video from all the
associated cameras.
Note For the Record action, the camera you select should be set to
the Event or Time & Event recording mode in the Record
Schedule setup screen.
Outputs appears. You can associate as many Alarm-Outs with that camera as you
wish. When the DVR detects motion on the selected camera's input, it triggers
output signals on all the associated Alarm-Out connectors. You can also have the
DVR's internal buzzer sound if motion is detected on the selected camera.
(Figure 3-66) screens display.
Motion Detection Actions 1 Screen
. Use the Up and Down arrow
. A list of cameras
. A list of Alarm
81