Cisco Unified Ip Phones Installation; Install Cisco Unified Sip Phone 3905 - Cisco 3905 Administration Manual

Cisco Unified IP Phone
Refer to the following sections in the Cisco Unified Communications Manager Administration Guide:
• End User Configuration Settings section in the End User Configuration chapter.
• Adding Users to a User Group section in the User Group Configuration chapter.
Step 7 (Optional) Associate a user with a phone.
Provides users with control over their phone such a forwarding calls or services.
Note
For more information, go to the Associating Devices to an End User section in the End User Configuration
chapter in the Cisco Unified Communications Manager Administration Guide.

Cisco Unified IP Phones Installation

After you have added the phones to the Cisco Unified Communications Manager database, you can complete
the phone installation. You (or the phone users) can install the phone at the location of the user.
Upgrade the phone with the current firmware image before you install the phone. For information about
Note
upgrading, refer to the Readme file for your phone, located at:
http://www.cisco.com/cgi-bin/tablebuild.pl/ip-7900serhttp://tools.cisco.com/support/downloads/go/
Redirect.x?mdfid=278875240
For instructions on upgrading the firmware, see the Release Notes, located at:
US/products/ps7193/prod_release_notes_list.html
After the phone is connected to the network, the phone startup process begins, and the phone registers with
Cisco Unified Communications Manager. To finish installing the phone, configure the network settings on
the phone depending on whether you enable or disable DHCP service.
If you used auto-registration, you need to update the specific configuration information for the phone such as
associating the phone with a user, changing the button table, or directory number.

Install Cisco Unified SIP Phone 3905

The following list provides an overview and checklist of installation tasks for the Cisco Unified SIP Phone
3905. The list presents a suggested order to guide you through the phone installation. Some tasks are optional,
depending on your system and user needs. For detailed procedures and information, refer to the sources in
the list.
Procedure
Step 1 Choose the power source for the phone:
• Power over Ethernet (PoE)
Some phones, such as those in conference rooms, do not have an associated
user.
Cisco Unified SIP Phone 3905 Administration Guide for Cisco Unified Communications Manager 8.6 (SIP)
Cisco Unified IP Phones Installation
http://www.cisco.com/en/
17