Cisco Unified Communications Manager User Addition; Add User From External Ldap Directory; Add User Directly To Cisco Unified Communications Manager - Cisco 3905 Administration Manual

Cisco Unified Communications Manager User Addition

• Five-digit internal telephone number: 26640
Cisco Unified Communications Manager User Addition
This section describes steps for adding a user to Cisco Unified Communications Manager. Follow one of the
procedures in this section, depending on your operating system and the manner in which you are adding the
user:

Add User from External LDAP Directory

If you added a user to an LDAP Directory (a non-Cisco Unified Communications Server directory), you can
immediately synchronize that directory to the Cisco Unified Communications Manager on which you are
adding this same user and the user's phone by following these steps:
Procedure
Step 1
Login to Cisco Unified Communications Manager Administration.
Step 2 Choose System > LDAP > LDAP Directory.
Step 3 Use Find to locate your LDAP directory.
Step 4 Click the LDAP directory name.
Step 5
Click Perform Full Sync Now.
Note
Step 6
Proceed to

Add User Directly to Cisco Unified Communications Manager

If you are not using an LDAP directory, you can add a user directly to Cisco Unified Communications Manager
Administration by following these steps:
Procedure
Step 1 Choose User Management > End User.
Step 2
Click Add New.
The End User Configuration window appears.
Step 3 In the User Information pane of this window, enter the following:
• User ID: Enter the end user identification name. Cisco Unified Communications Manager does not
Cisco Unified SIP Phone 3905 Administration Guide for Cisco Unified Communications Manager 8.6 (SIP)
106
If you do not need to immediately synchronize the LDAP Directory to the Cisco Unified
Communications Manager, the LDAP Directory Synchronization Schedule on the LDAP Directory
window determines when the next auto-synchronization is scheduled. However, the synchronization
must occur before you can associate a new user to a device.
Phone Setup, on page
permit modifying the user ID after it is created. You may use the following special characters: =, +, <,
>, #, ;, \, , "", and blank spaces.
107.
Basic Phone Administration Steps