Cisco 4300 User Manual page 66

Table 4-1
Control
Video Resolution
drop-down list
Right Arrow toggle
button
Left Arrow toggle
button
Video image controls
Note
White Balance slider
Brightness slider
Contrast slider
Sharpness slider
Cisco Video Surveillance 4300 and 4500 High-Definition IP Cameras User Guide
4-2
Camera Video/Control Window Controls (continued)
Description
Choose the resolution for video transmission. The resolutions in this
drop-down list depend on the video standard that you selected.
The default value for H.264 is 1920 x 1080. The default value for MJPEG is
704 x 480.
You cannot configure a secondary stream if you configure this resolution for
1920 x 1080.
Note You can also change the resolution for video transmission by changing
the value in the Video Resolution Type field, as described in the
"Streaming Settings Window" section on page
Click the Right Arrow to display the video image controls. The button changes
to the Left Arrow button.
Click the Left Arrow button to hide the video image controls. The button
changes to the Right Arrow button.
These controls appear when you click the Right Arrow in the Video Control area.
To control the white balance of the video image, drag the slider, or enter a
value from 1 through 100 and press the Enter key. A higher value increases
white balance and a lower value decreases white balance.
If the White Balance Mode option is not set to Manual as described in the
"Camera Settings Window" section on page
value sets that option to Manual automatically.
The default value is 50.
To control the brightness of the video image, drag the slider, or enter a value
from 1 through 100 and press the Enter key. A higher value increases the
brightness and a lower value decreases the brightness. For example, if the IP
camera is facing a bright light and the video appears too dark, you can increase
the brightness.
The default value is 50.
To control contrast of the video image, drag the slider, or enter a value from 1
through 100 and press the Enter key. A higher value increases the contrast and
a lower value decreases the contrast.
The default value is 50.
To control the sharpness of the video from the IP camera, drag the slider, or
enter a value from 1 through 100 and press the Enter key. A higher value
increases the sharpness and a lower value decreases the sharpness.
The default value is 50.
Chapter 4 Viewing Live Video
3-3.
3-6, changing the white balance
OL-19609-04