Qos Settings Window - Cisco 4300 User Manual

Chapter 3 Configuring and Managing the IP Camera
To display the IP Filtering window, access the configuration windows as described in the
the Initial Setup of the IP Camera" section on page
If you change any options in this window, you must click the Save Settings button to save the changes.
If you do not click this button, changes are not retained when you exit the window. Save Settings
appears at the bottom of the window. You may need to scroll down to it.
Table 3-15
Table 3-15
Option
IP Filter Area
Enable IP Filtering
Filter Entries Area
#
Action
IP Address/Bit Mask

QoS Settings Window

The QoS Settings window provides options for configuring quality of service (QoS) settings for
audio/video streams.
To display the QoS Settings window, access the configuration windows as described in the
the Initial Setup of the IP Camera" section on page
If you change any options in this window, you must click the Save Settings button to save the changes.
If you do not click this button, changes are not retained when you exit the window. Save Settings
appears at the bottom of the window. You may need to scroll down to it.
Table 3-16
Table 3-16
Option
Class of Service (CoS) Area
Enable CoS for Video
Streaming
Video Priority
Video VLAN ID
OL-19609-04
describes the options in the IP Filter Settings window.
IP Filter Settings Window Options
Description
Check this check box to cause the IP camera to allow or deny access to IP
addresses as configured in the IP Filtering window.
Display only. Filter number.
Choose an action for the corresponding IP address or address range:
Deny—IP address or address range cannot access the IP camera
•
Allow—IP address or address range can access the IP camera
•
Enter the IP address and bit mask to which the corresponding action applies.
Make these entries in Classless Inter-Domain Routing (CIDR) notation.
CIDR is defined in RFC 4632.
describes the options in the QoS Settings window.
QoS Settings Window Options
Description
Check this check box to enable class of service (CoS) control for video
streams.
If you enable this option, the IP camera specifies a VLAN tag that appends
to an Ethernet MAC frame for video streaming data.
Value from 0 (lowest priority) through 7 (highest priority) that specifies the
CoS priority value for steaming video data.
Enter the ID of the video VLAN to which CoS packets are directed.
Cisco Video Surveillance 4300 and 4500 High-Definition IP Cameras User Guide
2-5, click Network Setup, then click IP Filtering.
2-5, click Network Setup, then click IP Filtering.
Network Setup Windows
"Performing
"Performing
3-25