Safety Overview - Cisco 6500-E Installation And Verification Manual

Hardware Requirements
The hardware requirements for the modules are as follows:
•
•
•
•
•
•
•
Software Requirements
For software requirements, see the Release Notes for the Cisco Catalyst 6500 Series and the Cisco 7600
Series Communication Media Module at this URL:
http://www.cisco.com/en/US/products/hw/switches/ps708/prod_release_notes_list.html

Safety Overview

Throughout this publication, safety warnings appear in procedures that, if performed incorrectly, can
harm you. A warning symbol precedes each warning statement.
IMPORTANT SAFETY INSTRUCTIONS
Warning
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you
work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar
with standard practices for preventing accidents. Use the statement number provided at the end of
each warning to locate its translation in the translated safety warnings that accompanied this
device. Statement 1071
SAVE THESE INSTRUCTIONS
Cisco Communication Media Module for Catalyst 6500 Series Switch and Cisco 7600 Series Router Installation and Verification Note
Catalyst 6500 series switch.
Cisco 7600 series router.
252.0 Watts (6.00 A @ 42 V) of available system power
A Supervisor Engine 2, Supervisor Engine 720, or Supervisor Engine 32—The supervisor engine can
have an MSFC, MSFC2, or MSFC3, but the CMM does not require one for configuration or operation.
Supervisor Engine 32—The minimum version for the CMM is 12.4(3) and the recommended version is
12.4(7a). The minimum version for the Supervisor Engine 32 is 12.2(18)SXF4 and the recommended
version is 12.2(18)SXF4.
Port adapters—You can install up to three T1, E1, or FXS port adapters into slots 1 through 3 on
either base module.
You can install up to four ACT port adapters into either base module. (The internally located slot 4
is reserved for the ACT port adapter.)
You cannot mix T1 port adapters with E1 port adapters, but any other combination of port
Note
adapters is supported.
Module blank filler plate (WS-SVC-CMM-BLANK) for unused port adapter slots.
Safety Overview
7