Table Of Contents; Front Panel Descriptions; Cmm Module - Cisco 6500-E Installation And Verification Manual

Contents
Contents
This publication contains these sections:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Front Panel Descriptions
These sections describe the front panel features of the module and the port adapters:
•
•
•
•

CMM Module

The front panel features of the modules are as follows:
•
•
•
Cisco Communication Media Module for Catalyst 6500 Series Switch and Cisco 7600 Series Router Installation and Verification Note
2
Front Panel Descriptions, page 2
Requirements, page 6
Safety Overview, page 7
Required Tools, page 10
Installing and Removing the Module, page 10
Removing and Replacing Port Adapters, page 19
Verifying the Installation, page 25
RJ-45 Port Connector and Cabling Specifications, page 25
RJ-21 Port Connector and Cabling Specifications, page 27
Accessing the Port Adapter Ports, page 28
Configuring the Port Adapter Ports, page 29
Configuring the Port Adapter Clock Source, page 29
Disaster Recovery for Module Software Upgrades, page 30
Password Recovery, page 32
Regulatory Standards Compliance, page 33
Related Documentation, page 33
Obtaining Documentation, Obtaining Support, and Security Guidelines, page 33
CMM Module, page 2
6-Port T1 and E1 Port Adapters, page 4
24-Port FXS Port Adapter, page 5
Ad-Hoc Conferencing and Transcoding Port Adapter, page 6
STATUS LED-When the module powers up, it initializes various hardware components and
communicates with the supervisor engine. The STATUS LED shows the dialog with the supervisor
engine and the results of the initialization. During the normal initialization sequence, the STATUS
LED changes from off to red, to orange, and then to green.
operation.
Port adapter slots-Figure 1
a blank filler plate in the right slot.
REAR MODULE STATUS
and Figure 2 show the E1 port adapter in the left and middle slots, with
LED-Table 2 describes the REAR MODULE STATUS LED operation.
Table 1 describes the STATUS LED