Requirements; Ad-Hoc Conferencing And Transcoding Port Adapter - Cisco 6500-E Installation And Verification Manual

Requirements

Figure 3
Table 4
Color
Green
Off

Ad-Hoc Conferencing and Transcoding Port Adapter

The front panel features of the ad-hoc conferencing and transcoding port adapter are shown in
and the STATUS LED is described in
Figure 4
Table 5
Color
Green
Red
Off
Requirements
These sections describe the hardware and software requirements:
•
•
Cisco Communication Media Module for Catalyst 6500 Series Switch and Cisco 7600 Series Router Installation and Verification Note
6
24-Port FXS Port Adapter Front Panel Features
Receive port LEDs
WS-SVC-CMM-24FXS
FXS Interface Board Adapter
RJ-21 connector
24-Port FXS Port Adapter Receive Port LEDs
Description
Port is off-hook or ringing.
Port is not active (connected device on-hook) or is disabled through
the CLI.
Ad-Hoc Conferencing and Transcoding Port Adapter Front Panel Features
WS-SVC-CMM-ACT
Ad-hoc Conferencing and Transcoding Port Adapter
Ad-Hoc Conferencing and Transcoding Port Adapter STATUS LED
Description
Port adapter is up and operational.
Port adapter is shut down.
Port adapter is not located by the system.
Hardware Requirements, page 7
Software Requirements, page 7
Table 5.
Figure 4,