Disaster Recovery For Module Software Upgrades - Cisco 6500-E Installation And Verification Manual

Disaster Recovery for Supervisor Engines Running Catalyst Operating System
Software
To perform disaster recovery on systems that use the Catalyst operating system software on the
supervisor engine, perform these steps:
Before performing the disaster recovery, remove the port adapters from the CMM.
Step 1
See the
Step 2 Enter the copy tftp [device] command to copy the golden image for the CMM to the supervisor engine
flash memory where [device] can be any flash file system on the supervisor engine.
Enter the set filename-alias [alias-name] [device]:[golden-image] command to translate the filename of
Step 3
the downloaded file.
The [golden-image] is the file to be downloaded, and the [device] can be any flash file system on the
supervisor engine. See
supervisor engine type in use.
Enter the set module power down [mod] [pm_option] command to power down the CMM.
Step 4
See
use.
Enter the set poll disable command to disable polling.
Step 5
Enter the set module power up [mod] command to power up the CMM.
Step 6
When the CMM powers up, disaster recovery is complete.
After you complete the disaster recovery, enter the clear filename-alias [alias-name] command to
Step 7
terminate the filename translation.
Set the power management option for the CMM to zero (0).
Step 8
This step is necessary to prevent the download mechanism from triggering every time that the CMM is
reset.
Enter the set poll enable command to enable polling.
Step 9
Disaster Recovery for Supervisor Engines Running Cisco IOS Software
This procedure requires supervisor engine software release 12.2(18)SFX or later.
Note
To perform disaster recovery on systems that use Cisco IOS software on the supervisor engine, perform
these steps:
Step 1 Before performing the disaster recovery, remove the port adapters from the CMM.
See the
Step 2 Enter the copy tftp [device] command to copy the golden image for the CMM to the supervisor engine
flash memory where [device] can be any flash file system on the supervisor engine.
Cisco Communication Media Module for Catalyst 6500 Series Switch and Cisco 7600 Series Router Installation and Verification Note
"Removing and Replacing Port Adapters" section on page 19
Table 8
Table 8 for configuring the appropriate [pm_option] corresponding to the supervisor engine type in
"Removing and Replacing Port Adapters" section on page 19
for configuring the appropriate [alias-name] corresponding to the

Disaster Recovery for Module Software Upgrades

for removal procedures.
for removal procedures.
31