Cisco 6500-E Installation And Verification Manual page 15

Figure 8
FAN
STATUS
o
INPUT
OK
Carefully slide the module into the slot until the EMI gasket along the right edge of the module
b.
makes contact with the module in the slot adjacent to it and both ejector levers have closed to
approximately 45 degrees with respect to the module faceplate. (See
c. Using the thumb and forefinger of each hand, grasp the two ejector levers and exert a slight pressure
to the left, deflecting the module approximately 0.040 inches (1 mm) to create a small gap between
the module's EMI gasket and the module adjacent to it. (See
Cisco Communication Media Module for Catalyst 6500 Series Switch and Cisco 7600 Series Router Installation and Verification Note
Positioning the Module in a Vertical Slot Chassis
o
FAN OUTPUT
OK FAIL
INPUT FAN OUTPUT
OK OK FAIL
Insert module
between slot guides
Ejector lever fully
extended
EMI
gasket
EMI
gasket
Figure
Installing and Removing the Module
Figure 9.)
9.)
15