Hardware Installation - Draytek Vigor2820 Series User Manual

1 . 3 H a r d w a r e
1 . 3 H a r d w a r e
Before starting to configure the router, you have to connect your devices correctly.
1. Connect the ADSL interface to the external ADSL splitter with an ADSL line cable for
all models. For Vigor2820Vn/VS/VSn, also connect Line interface to external ADSL
splitter.
For second WAN, connect the cable Modem/DSL Modem/Media Converter to WAN2
port of router with Ethernet cable (RJ-45).
2. Connect one end of an Ethernet cable (RJ-45) to one of the LAN ports of the router and
the other end of the cable (RJ-45) into the Ethernet port on your computer.
3. Connect the telephone set with phone lines (for using VoIP function). For the model
without phone ports, skip this step.
4. Connect one end of the power adapter to the router's power port on the rear panel, and
the other side into a wall outlet.
5. Power on the device by pressing down the power switch on the rear panel.
6. The system starts to initiate. After completing the system test, the ACT LED will light
up and start blinking.
(For the hardware connection, we take "Vn" model as an example.)
I n s t a l l a t i o n
I n s t a l l a t i o n
15
Vigor2820 Series User's Guide