Inventory - Grizzly G0709 Owner's Manual

Inventory

The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Mounted Inventory components
A. three-Jaw Chuck 6" ................................... 1
b. steady rest ................................................ 1
c. Follow rest ................................................. 1
D. Quick Change tool post w/holder ............. 1
Loose Inventory components
E. Four-Jaw Chuck 8" ..................................... 1
f. toolbox ....................................................... 1
G. Four-Jaw Chuck Wrench ............................ 1
H. Faceplate 11" .............................................. 1
I.
Faceplate Camlock set .............................. 1
Toolbox Inventory components
J.
Bottle for oil ............................................... 1
K. spindle sleeve Mt#5/Mt#3 ....................... 1
L. dead Center Mt#3 Carbide tip ................. 1
M. dead Center Mt#3 hss tip ...................... 1
N. live Center Mt#3 ....................................... 1
O. tailstock lock lever ................................... 1
p. handles ...................................................... 2
Q. Chuck Arbor Mt#3/Jt3 ............................. 1
R. hex Wrench set 6, 8mm ................... 1 each
S. "t" Wrench ................................................. 1
T.
three-Jaw Chuck Key ................................ 1
U. phillips and standard screwdriver #2 ........ 1
v.
open-end Wrench set
9/11, 10/12, 12/14mm ......................... 1 each
W. drill Chuck Key ........................................... 1
X. drill Chuck
⁄ "-Jt3 .................................... 1
1
2
y. tool holder (one installed) ........................ 2
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
-14-
A
Qty
figure 3. Mounted inventory components.
Qty
e
Qty
g
figure 4. loose inventory components.
K
J
figure 5. toolbox inventory.
B
C
F
h
i
n
M
l
r
Q
s
W
t
v
u
Model G0709 (Mfg. Since 5/11)
d
o
p
X
y