Section 3: Setup; Preparation; Unpacking; Needed For Setup - Grizzly G0709 Owner's Manual

preparation

the list below outlines the basic process of pre-
paring your machine for operation. specific steps
are covered later in this section.
The typical preparation process is as follows:
1. unpack the lathe and inventory the contents
of the box/crate.
2. Clean the lathe and its components.
3. identify an acceptable location for the lathe
and move it to that location.
4. level the lathe and bolt it to the floor.
5. Assemble the loose components and make
any necessary adjustments or inspections to
ensure the lathe is ready for operation.
6.
Check lathe for proper lubrication.
7.
Connect the lathe to the power source.
8. test run lathe to ensure it functions properly.
9. perform the spindle break-in procedure to
prepare the lathe for operation.
Model G0709 (Mfg. Since 5/11)

SEcTION 3: SETUp

Unpacking

Your machine was carefully packaged for safe
transportation. Remove the packaging materials
from around your machine and inspect it. If you
discover any damage, please call us immediately
at (570) 546-9663 for advice.
Save the containers and all packing materials for
possible inspection by the carrier or its agent.
Otherwise, filing a freight claim can be difficult.
When you are completely satisfied with the condi-
tion of your shipment, inventory the contents.
SUFFOCATION HAZARD!
Keep children and pets away
from plastic bags or packing
materials shipped with this
machine. Discard immediately.

Needed for Setup

the following are needed to complete the setup
process, but are not included with your machine.
Description
• Forklift or hoist (rated 2000 lbs.) .............. 1
• lifting straps (rated 2000 lbs.) .................. 2
• lifting hooks (rated 2000 lbs.) .................. 2
• Machinist's level ........................................ 1
• degreaser/solvent Cleaner ......... as needed
• shop rags for Cleaning .............. as needed
• stiff Brush for Cleaning .............................. 1
Qty
-13-