Inventory - Grizzly G0733 Owner's Manual

Inventory

Inventory
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Inventory (Figures 3–6)
A. Lathe Assembly
—Headstock (mounted) ............................. 1
—Tool Rest Base (mounted) ...................... 1
—Tailstock (mounted) ................................. 1
—Faceplate 6" (installed) ........................... 1
B. Stand Legs ................................................. 2
C. Machine Feet .............................................. 4
D. Tool Rest .................................................... 1
E. Live Center MT#2 ....................................... 1
F.
Spur Center MT#2 ...................................... 1
G. Indexing Pin ................................................ 1
H. Hex Wrenches 3, 4, 6, 8, 10mm ............1 Ea
I. Knockout Tool ............................................. 1
J.
Storage Basket ........................................... 1
K. Hardware (not shown)
—Cap Screws M8-1.25 x 35 ...................... 2
—Lock Washers 8mm ................................ 2
—Hex Nuts M8-1.25 ................................... 2
—Cap Screws M10-1.5 x 35 ....................... 8
—Lock Washers 10mm .............................. 8
A
Figure 3. Lathe assembly.
Model G0733 (Mfd. Since 5/19)
Qty
C
Figure 5. Loose inventory components.
J
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
B
Figure 4. Stand legs.
E
F
D
I
Figure 6. Storage basket.
NOTICE
G
H
-13-