Inventory; Cleanup - Grizzly G9972Z Owner's Manual

Inventory

The following is a description of the main compo-
nents shipped with your machine. Lay the compo-
nents out to inventory them.
Note: If you can't find an item on this list, check
the mounting location on the machine or examine
the packaging materials carefully. Occasionally
we pre-install certain components for shipping
purposes.
Inventory (Figure 6)
A. Lathe 11" x 26" (not shown) ........................ 1
B. Faceplate 8" ............................................... 1
C. Toolbox ....................................................... 1
D. Steady Rest ................................................ 1
E. Follow Rest ................................................. 1
F.
4-Way Tool Post ......................................... 1
G. 3-Jaw Chuck 5" .......................................... 1
H. 4-Jaw Chuck 6 ⁄ " ....................................... 1
1
2
I.
3-Jaw Chuck Key ....................................... 1
J. Dead Center MT#4 ..................................... 1
K. External Jaws for 3-Jaw Chuck .................. 3
L. Dead Center MT#3 ..................................... 1
M. Change Gears 28, 35, 63, 69, 70, 77, 78T
.......................................................... 1 Each
N. Screwdrivers Standard/Phillips .......... 1 Each
O. Spanner Wrench ........................................ 1
P. Hex Wrenches 3, 4, 5, 6, 8mm ......... 1 Each
Q. Wrenches 8/10, 12/14, 17/19mm ........ 1 Each
R. 4-Jaw Chuck Key ....................................... 1
S. V-belt 3L290 (not shown) ........................... 1
T.
Splash Pan (not shown) ............................. 1
B
C
H
G
K
I
J
L
R
Q
Figure 6. Model G9972Z inventory.
Model G9972Z (Mfd. Since 03/20)
Qty
D
E
F
M
N
P
O

Cleanup

The unpainted surfaces of your machine are
coated with a heavy-duty rust preventative that
prevents corrosion during shipment and storage.
This rust preventative works extremely well, but it
will take a little time to clean.
Be patient and do a thorough job cleaning your
machine. The time you spend doing this now will
give you a better appreciation for the proper care
of your machine's unpainted surfaces.
There are many ways to remove this rust preven-
tative, but the following steps work well in a wide
variety of situations. Always follow the manufac-
turer's instructions with any cleaning product you
use and make sure you work in a well-ventilated
area to minimize exposure to toxic fumes.
Before cleaning, gather the following:
• Disposable rags
• Cleaner/degreaser (WD•40 works well)
• Safety glasses & disposable gloves
• Plastic paint scraper (optional)
Basic steps for removing rust preventative:
1. Put on safety glasses.
2. Coat the rust preventative with a liberal
amount of cleaner/degreaser, then let it soak
for 5–10 minutes.
3.
Wipe off the surfaces. If your cleaner/degreas-
er is effective, the rust preventative will wipe
off easily. If you have a plastic paint scraper,
scrape off as much as you can first, then wipe
off the rest with the rag.
4. Repeat Steps 2–3 as necessary until clean,
then coat all unpainted surfaces with a quality
metal protectant to prevent rust.
NOTICE
Avoid harsh solvents like acetone or brake
parts cleaner that may damage painted sur-
faces. Always test on a small, inconspicu-
ous location first.
-15-