Playback Tape Playback; Using Earphones (Commercially Available) - Sharp ViewCam VL-MC500S Operation Manual

Basic Operations
Playback
Tape Playback
Available mode:
Tape Playback
The LCD monitor screen functions as a handy
playback monitor. Nothing needs to be
connected, allowing instant on-screen play-
back with the sound through the built-in
speaker.
Power switch
Operation button
Media Selection switch
1
Set the Media Selection switch
to V.
2
Hold down the Lock button
and set the Power switch to
w.
3
Press j (or k) on the Operation button
to rewind (or fast forward) the tape to the
desired point.
4
Press m to begin playback.
Note:
• If you press the Start/Stop button in Tape
Playback mode, the "g" mark appears and the
camcorder enters Recording Standby mode. If
you do not intend to record, press l to turn the
"g" mark off, then press m to begin playback.
This will ensure your previous recording is not
erased (see pages 57, 59).
To stop playback
Press l.
To turn the power off
Set the Power switch to OFF without pressing
the Lock button.
Note:
• The tape automatically rewinds when playback
reaches the end of the tape.
Using Earphones
(Commercially
Available)
Available modes:
Tape Playback, Tape Camera
You can monitor the sound via stereo ear-
phones (commercially available) during
playback or recording. Stereo earphones with a
3.5 mm diameter plug can be used with this
camcorder.
Connect the plug of stereo earphones to the
earphones jack on the camcorder as shown
below.
Lock button
Notes:
• Before connecting stereo earphones, turn the
camcorder volume down to the lowest setting.
• The built-in speaker automatically turns off when
stereo earphones are connected to the ear-
phones jack.
Earphones jack
21