Inserting And Removing A Card - Sharp ViewCam VL-MC500S Operation Manual

Preparation
Inserting and Removing
a Card
You can use an SD Memory Card (supplied) or
a MultiMediaCard (commercially available) for
storing still images.
Inserting
1
Make sure that the Power switch is set
to OFF.
2
Slide the card slot cover release.
• The card slot cover will open automati-
cally.
3
Insert a card into the slot as shown
below, and push it in fully.
Write-protect
switch
Label
4
Close the card slot cover.
12
Card slot cover
release
Clipped corner
Removing
Perform steps 1 and 2 above, push the card
and release slowly (1). Then pull the card
straight out (2) as shown below.
Notes:
• You can use only the SD Memory Card or the
MultiMediaCard (see page 84).
• The supplied card is preformatted for immediate
use.
• See pages 84 and 85 for more information on the
cards intended for use with this camcorder.
Caution:
• Do not remove the card from the camcorder
while recording data on the card (S indicator
flashes during recording). This may delete the
recorded image or damage the card.
About the write-protect switch
SD Memory Card has a write-protect switch.
When the switch is set to the locked position,
you cannot record/delete data or format the
card. Set it to the unlocked position to record/
delete data or format the card.
Back view
Unlocked position
Locked position