Selecting The Date And Time Of Recording Display - Sharp ViewCam VL-MC500S Operation Manual

Selecting the Date and
Time of Recording
Display
Available modes:
All modes
Follow the procedure below to select the date,
or both the date and time, of recording display
on the screen. You can display the date and
time during both recording and playback.
• The example screens shown are for Tape
Playback mode.
1
Hold down the Lock button and set the
Power switch to v or w.
2
Press the DISPLAY button until the
mode screen appears.
G AMMA
AU D I O DUB
M E N U
MULTI
3
Press l or m on the Operation button
to select "DATE DISP.".
AU D I O DU B
M E N U
MULTI F R AME
D A T E D I S P .
4
Press the centre of the Operation button
until the desired setting appears.
DATE D I S P.
• Each time you press the centre of the
Operation button, the setting changes
as shown below.
DA T E + T I ME
O F F
F R AME
S E L E C T S E T
D A T E + T I ME
S E L E C T S E T
DA T E
DATE
OFF
5
Press the DISPLAY button until the date
(or date and time) appears.
A U T O
3 0 min
Notes:
• The date (or date and time) appears when the
on-screen indicators are turned on.
• Before recording, make sure that the date and
time have been correctly set. If they have not
been set, the display will be left blank when
playing back the recording. (The display will also
be left blank for unrecorded or damaged
portions of the tape.)
• In Tape Playback mode, the current date and
time are displayed when the tape is not being
played back.
• You can also press the DATE button on the
remote control to display the date (or date and
time).
. 2 . 6 2 0 0 3
41