Installing The Lithium Batteries - Sharp ViewCam VL-MC500S Operation Manual

Installing the Lithium
Batteries
Installing the Memory Battery
The supplied CR1616 type lithium battery is
used to store the memory of the date and time
settings.
1
Rotate the lens section of the
camcorder.
2
Pull out the lithium battery cover while
pressing the tab toward the centre.
Lithium battery cover
3
Insert the lithium battery into the battery
holder with the H side of the battery
facing the m side of the holder.
4
Close the lithium battery cover firmly
until it clicks into place.
Removing the Memory Battery
Perform steps 1 and 2 above,
then lift out the battery by using
a pointed object such as the tip
of a ballpoint pen.
Tab
CR1616 type
lithium battery
Installing the Battery to Re-
mote Control
The supplied CR2025 type lithium battery is
used to power the remote control unit.
1
Hold the remote control facing down,
and pull out the battery holder while
pressing the tab toward the centre.
Tab
2
Insert the lithium battery into the battery
holder with the H side of the battery
facing the m side of the holder.
H side, CR2025 type
lithium battery
3
Insert the battery holder back into
position.
Notes on the Use of the Lithium battery
CAUTION: Danger of explosion if battery is
incorrectly replaced. For camcorder, replace
only with same or equivalent type CR1616, for
remote control unit, replace only with same or
equivalent type CR2025, both recommended
by the equipment manufacturer.
X KEEP THIS BATTERY AWAY
FROM CHILDREN. IF SWALLOWED,
CONSULT A PHYSICIAN IMMEDIATELY FOR
EMERGENCY TREATMENT.
Z BATTERY MAY EXPLODE IF
MIS-USED OR INSTALLED WITH POLARITY
REVERSED. DO NOT RECHARGE, DISAS-
SEMBLE OR DISPOSE OF IN FIRE.
• Do not short-circuit, recharge, disassemble, or
heat the lithium battery.
• Should the lithium battery leak, wipe the battery
compartment clean, and then insert a new
battery.
• The lithium batteries will last about one year
under normal usage.
"m" mark
13