NETGEAR WNDAP350 - ProSafe 802.11n Dual Band Wireless Access Point User Manual page 99

ProSafe Dual Band Wireless-N Access Point WNDAP350 Reference Manual
When you click the Edit button, you must enter the profile name and the MAC address
(physical address) of the other bridge mode wireless station in the fields provided. WEP,
WPA-PSK, or WPA2-PSK are supported. WPA2-PSK can (and should) be used to protect this
communication.
The screens used to configure these options are located by selecting Wireless Bridge under the
Configuration tab (see
Figure 4-6 Enable Wireless Point-to-Point Bridge
To configure bridge settings on the Bridging page shown in
1. Select the Enable Wireless Bridging option.
2. Select one of the bridge mode options, Wireless Point to Point Bridge, or Wireless Point to
Multi-Point Bridge.
3. Select Enable Wireless Client Association, if you wish.
4. Click Edit to edit the security profile of the wireless bridge settings, as shown in
below.
Advanced Configuration
Figure 4-6 below).
v1.1, November 2009
Figure 4-6 above, follow these steps:
Figure 4-7
4-11