NETGEAR WNDAP350 - ProSafe 802.11n Dual Band Wireless Access Point User Manual page 79

ProSafe Dual Band Wireless-N Access Point WNDAP350 Reference Manual
Under the Monitoring tab on the main menu, select System to view the System screen, shown in
Figure 3-11 below. This screen shows the parameters listed in
Table 3-1. System Information Fields
Field
Access Point Information
Access Point Name
Ethernet MAC Address
Wireless MAC address for
2.4GHz
Wireless MAC address for
5GHz
Country/Region
Firmware Version
Current Time
Current IP Settings
IP Address
Subnet Mask
Default Gateway
DHCP Client
Current Wireless Settings for 802.11b/bg/ng
Operating Mode
Channel/Frequency
Rogue AP Detection
Current Wireless Settings for 802.11n/na
Operating Mode
Management
Description
Indicates the NetBIOS name. The default name may be changed, if desired.
Displays the Media Access Control address (MAC address) of the wireless
access point's Ethernet port.
Displays the Media Access Control address (MAC address) of the wireless
access point's wireless card when operating at 2.4GHz
Displays the Media Access Control address (MAC address) of the wireless
access point's wireless card when operating at 5GHz
Displays the domain or region for which the wireless access point is
licensed for use. It may not be legal to operate this wireless access point in
a region other than one of those identified in this field.
The version of the firmware currently installed.
Displays the current system time of the access point.
The IP address of the wireless access point.
The subnet mask for IP address of the wireless access point.
The default gateway for the wireless access point communication.
Enabled indicates that the current IP address of the AP was obtained from a
DHCP server on your network. Disabled indicated a static IP configuration.
Identifies the 802.11 operating mode of the WNDAP350.
Identifies the channel the wireless port is using. 'Auto' is the default channel
setting. (Channel frequencies used on each channel can be found in "Wire-
less Communications"; a link to this article is in
).
Documents.
Identifies whether the Rogue AP detection feature is enabled or disabled.
Identifies the 802.11 operating mode of the WNDAP350.
v1.1, November 2009
Table 3-1:
Appendix B, "Related
3-13