NETGEAR WNDAP350 - ProSafe 802.11n Dual Band Wireless Access Point User Manual page 130

ProSafe Dual Band Wireless-N Access Point WNDAP350 Reference Manual
rate 3-16
SSID 3-16
state 3-16
status 3-16
type 3-16
wireless network name (SSID)
B
back off 1-4
Basic Service Set (BSS) 1-2
Basic Service Set Identifier (BSSID)
beacon generation, support for
beacon interval 4-5, 4-7
bridge
network authentication
bridge mode wireless station
wireless point to point bridge
wireless point-to-multi-point bridge
BSSID 3-16
C
Category 5 Ethernet cable
change password 3-10
channel auto
testing connectivity 2-22
channel auto selection 2-22
channel interference 2-22
channel spacing 2-3, 2-19
channel spacing, recommended
channel width 2-19
channel, auto
configuring channel/frequency
channel, default 2-16
CLI
command set 3-4
command line interface (CLI)
configuration file 3-6
backup or restore 3-7
country/region, configure
coverage 2-2
Index-2
3-16
1-2
1-4
2-25
4-10
4-10
1-6
2-16
2-16
3-3
2-6
v1.1, November 2009
coverage area 1-1, 2-11
CSMA/CA 4-5, 4-7
CSMA/CD (Carrier Sense Multiple Access with
Collision Detection) 4-5, 4-7
CTS (Clear to Send) 4-5
D
data encryption settings
128 bits WEP 2-26
152 bits WEP 2-26
64 bits WEP 2-26
AES 2-26
none 2-26
TKIP 2-26
TKIP + AES 2-26
data rates 802.11a/na 2-19
data rates 802.11bgn 2-17
default access point name
default channel 2-16, 2-22
default gateway, configure
default IP address 2-5, 2-13
default password 2-5
default reset button 3-9
default SSID 2-11
default SSID 802.11a/n 2-24
default SSID 802.11b/g/n
default user name 2-5
default wireless access point name
DHCP
point-to-multi-point bridging
DHCP client
default setting 2-11
DHCP client, configure 2-13
DHCP client/server
support 1-2
DHCP server
configure 4-1
on LAN 2-13
on LAN, assigns IP address
distributed coordinated function, support for
2-6
2-14
2-24
2-11
4-15
2-11
1-4