NETGEAR WNDAP350 - ProSafe 802.11n Dual Band Wireless Access Point User Manual page 103

ProSafe Dual Band Wireless-N Access Point WNDAP350 Reference Manual
• If using DHCP, all WNDAP350 wirelss access points should be set to "Obtain an IP
address automatically (DHCP Client)" in the IP Address Source portion of the Basic IP
Settings menu.
• All WNDAP350 wirelss access points use the same SSID, Channel, authentication mode,
if any, and encryption in use.
• All Point-to-Point Access Points must have the AP2 MAC address in its Remote AP MAC
address field.
4. Verify connectivity across the LANs.
• A computer on any LAN segment should be able to connect to the Internet or share files
and printers with any other PCs or servers connected to any of the three LAN segments.
• Wireless stations will be able to connect to the WNDAP350 wirelss access points in the
illustration above. If you require wireless stations to access any LAN segment, you can
add additional WNDAP350 wirelss access points configured in Wireless Access Point
mode to any LAN segment.
5. Click Apply to save your settings.
Note: You can extend this multi-point bridging by adding additional WNDAP350s
configured in Point-to-Point mode for each additional LAN segment. Furthermore,
you can extend the range of the wireless network with NETGEAR wireless antenna
accessories.
Advanced Configuration
v1.1, November 2009
4-15