Configuring Wpa With Radius - NETGEAR WNDAP350 - ProSafe 802.11n Dual Band Wireless Access Point User Manual

ProSafe Dual Band Wireless-N Access Point WNDAP350 Reference Manual
5. Wireless Client Security Separation is disabled by default. If enabled, associated wireless
clients will not be able to communicate with each other. (This feature is intended for hotspots
and other public access situations.
6. Click Apply to save your settings.
Note: If you use a wireless computer to configure WEP settings, you will be
disconnected when you click Apply. Reconfigure your wireless adapter to match
the new settings or access the wireless access point from a wired computer to
make any further changes.

Configuring WPA with RADIUS

Not all wireless adapters support WPA. Furthermore, client software is required on the client.
Windows XP and Windows 2000 with Service Pack 3 or above do include the client software that
supports WPA. Nevertheless, the wireless adapter hardware and driver must also support WPA.
Consult the product document for your wireless adapter and WPA client software for instructions
on configuring WPA settings.
To configure WPA, follow these steps:
1. Under the Configuration tab, select Security on the main menu, select
left-hand menu, and then select RADIUS Server Settings. The RADIUS Server Settings
screen displays.
2. Enter the RADIUS Server Settings as shown in
page 2-29.
3. Click Apply to save your RADIUS Server settings.
Basic Installation and Configuration
"Configuring the RADIUS Server Settings" on
v1.1, November 2009
Advanced from the
2-35