NETGEAR GS724AT - ProSafe Gigabit Smart Switch Software Administration Manual page 38

• Jumbo Frames Status – Displays the Jumbo Frame status.
• Jumbo Frames After Reset – Select the Jumbo Frame status. The possible field values
are:
– Enable – Enable Jumbo Frames.
– Disable – Disable Jumbo Frames.
The Versions Table displays the following fields:
• Model Name – Displays the device model name.
• Hardware Version – Displays the installed device hardware version number.
• Boot Version – Displays the current boot version running on the device.
• Software Version – Displays the installed software version number.
2. Enter the System Name, System Location, System Contact and Idle Timeout in the
provided fields.
3. Select whether to enable or disable Jumbo Frames After Reset.
4. Click Apply to update the system settings.
IP Configuration
The IP Configuration screen contains fields for assigning IP addresses. IP addresses are either
defined as static or are retrieved using the Dynamic Host Configuration Protocol (DHCP). The IP
Interface screen also contains information for defining default gateways. DHCP is also configured
from the IP Interface screen. The DHCP assigns dynamic IP addresses to devices on a network.
DHCP ensures that network devices can have a different IP address every time the device connects
to the network.
Note the following when configuring IP Addresses:
• If the device is accessed using SmartWizard Discovery, the IP address retrieved through
DHCP is displayed.
• If the device fails to retrieve an IP address through DHCP, the default IP address is
192.168.0.239.
Managing System Settings
GS700AT Series Smart Switch Software Administration Manual
v1.0, March 2008
3-3