NETGEAR GS724AT Installation Manual

GS700AT Gigabit Smart Switch
Follow these instructions to set up your smart switch. Before proceeding with the smart
switch installation, familiarize yourself with the contents of the Resource CD, especially
the reference manuals on your Resource CD.
First, Verify Package Contents
• NETGEAR Smart Switch
• Rubber footpads for tabletop installation
• Power cord
• Rack-mount kit for installing the switch in a 19-inch rack
• Installation Guide
• Smart Switch Resource CD with Smartwizard Discovery utility and Hardware
Installation Guide. (A link to the online Software Administration User's Manual is on
the Resource CD.)
• Warranty/Support Information Card
Then, Prepare to Install Your Smart Switch
First, prepare a PC with an Ethernet adapter and a CD ROM drive.
Next, Install the Smartwizard Discovery
Utility on a PC
1. Insert the Resource CD into your CD drive.
2. Run the Setup program to install the Smartwizard Discovery utility. The Installation
Wizard will guide you through.
Next, Connect Your Smart Switch in the
Correct Order
These instructions assume you are using DHCP in your network. If you are using static IP
addressing in your network, configure the switch IP address before connecting it to your
network. In the absence of a DHCP server, the switch defaults to 192.168.0.239 for its IP
address.
To configure the switch before connecting it to your network:
1. Set up the PC with an IP address in the 192.168.0.x subnet, and connect the PC to the
switch. Then, use the SmartWizard Discovery utility to configure the switch.
2. Connect each PC to an RJ-45 network port on the Switch front panel.
Use category 5 (Cat5) unshielded twisted-pair (UTP) cable terminated with an RJ-45
connector to connect.
Figure 1
3. Connect the smart switch to your network.
4. Power on the switch.
5. Verify that the PC with the Smartwizard Discovery utility is on the same subnet as the
switch.
Now, Configure the Switch with the
Smartwizard
1. Click Start > Programs and run Smartwizard.
Figure 2
2. Click Discover to find your switch in the network.
Figure 3