Basic Wireless Configuration - NETGEAR WC7520 - ProSafe 20-AP Wireless Controller Reference Manual

ProSafe 20-AP Wireless Controller WC7520 Reference Manual

Basic Wireless Configuration

To configure basic wireless settings:
1. Select Configuration > Wireless > Basic > Wireless. The Basic Wireless Settings
screen displays:
Figure 40.
2. Configure the settings as explained in
3. Click Apply to save your settings.
Table 17. Wireless Settings
Field
Wireless Mode
Data Rate
Table 17, Wireless Settings
Description
Specify the wireless mode for the access points. Access points use the mode
enabled for the group, unless the access point does not support the group setting. In
that case, the access point uses the mode providing highest performance.
The default setting is 802.11ng mode. A license (WC75NL) is required for this mode.
See Licenses on page 15.
• If you specify 802.11b or 802.11bg mode, both 802.11n- and 802.11g-compliant
devices can be used with this access point. However, 802.11b devices will not be
able to connect.
• If you select this option and other settings on this screen are disabled, then you
must select the Turn Radio On check box to enable available options on this
screen.
Select the available transmit data rates of the wireless network.
on page 71.
Chapter 7: Configuring Wireless Settings | 71