NETGEAR WC7520 - ProSafe 20-AP Wireless Controller Reference Manual page 123

ProSafe 20-AP Wireless Controller WC7520 Reference Manual
2. Configure the settings as explained in
Table 35. Redundancy Settings
Setting
Enable Redundancy
Controller Mode
Redundancy ID
Controller IP
Primary IP
Secondary IP
3. Click Apply to save your settings.
Table 35.
Description
Select this check box to enable the redundancy feature and to unmask the
configuration fields that enable you to configure this wireless controller to
become part of a redundancy group.
Specify if the wireless controller functions as a primary or secondary controller
by selecting the Primary or Secondary radio button.
Enter a number (1-255) as the ID for the redundancy group.
Enter the common IP address that is used by both the primary and secondary
controller in this redundancy group.
Note: This address is used for controller administration and is assumed by the
primary controller; after a failover has occurred, the address is assumed by the
secondary controller.
Enter the IP address of the primary controller (see
Settings on page 57).
Enter the IP address of the secondary controller (see
Settings on page 57).
Chapter 10: Managing Stacking and Redundancy
Configuring IP and VLAN
Configuring IP and VLAN
| 123