Viewing The Wireless Controller Summary Screens - NETGEAR WC7520 - ProSafe 20-AP Wireless Controller Reference Manual

ProSafe 20-AP Wireless Controller WC7520 Reference Manual

Viewing the Wireless Controller Summary Screens

Figure 92.
Table 43 explains the fields of the Network Status, Wireless Clients, and Rogue Access Points,
and Network Info tables on the Controller Summary screen.
Table 43. Controller Summary Screen Information
Setting
Network Status
For each access point and client, the following information is displayed:
Up
Total
Down
Critical
Major
Alarms
Wireless Clients
For each wireless client, the following information is displayed:
Open
WEP
WPA
Description
The total number of managed devices that are running properly.
The total number of managed devices that cannot be pinged.
The wireless controller can ping these managed devices, but either cannot log in or
has detected that these device are different from the ones that were configured.
The number of managed devices for which the configuration differs from the one
that is set on the wireless controller. This situation occurs most likely because the
device runs outdated firmware or the wireless controller changed the configuration
while the device was down or offline.
The number of wireless clients that are connected to managed access points using
security profiles configured with open mode.
The number of wireless clients that are connected to managed access points using
security profiles configured with WEP.
The number of wireless clients that are connected to managed access points using
security profiles configured with WPA.
Chapter 11: Monitoring the Wireless Network and Components | 135