Configuring a Host Name
Configuring a Host Name
Cisco Content Services Switch Getting Started Guide
2-22
Table 2-3
describes the fields in the show sntp global command output.
Table 2-3
Field Descriptions for the show sntp global Command
Field
Server Address
Version
Poll Interval
TimeSinceLastUpdate
Server Status
The Host table is the static mapping of mnemonic host names to IP addresses,
which is analogous to the ARP table. Use the host command to manage entries in
the Host table of the CSS.
The syntax for this global configuration mode command is:
host host_name ip_address
The variables are as follows:
host_name - The name of the host. Enter an unquoted text string with no
•
spaces and a length from 1 to 16 characters.
ip_address - The address associated with the host name. Enter the IP address
•
in dotted-decimal notation (for example, 192.168.11.1).
To add a host to the Host table, the host name must not exist in the Host table. To
change a current host address, remove the host name and then add it again to the
Host table with the new address.
For example:
(config)# host CSS11501-LML 192.168.3.6
Description
The IP address for the SNTP server.
The version number of the server. The default is 1.
The time in seconds between SNTP request messages.
The range is 16 to 16284. The default is 64.
The time in seconds since the last server reply.
The operating status of the SNTP server, Up or Down.
Chapter 2
Configuring CSS Basics
OL-6037-01