Cisco CSS 11501 - Content Services Switch Getting Started Manual page 31

Chapter 1 Booting, Logging In, and Getting Started
Logging in to the CSS
OL-6037-01
Table 1-2 Status LEDs Boot Definitions (continued)
State Sequence
The CSS 11501, or a module in the CSS 11503
4.
or CSS 11506, is on line and active.
The CSS 11501 or a module in the CSS 11503 or
CSS 11506 (except a Fast Ethernet Module)
failed.
In the CSS 11503 or 11506, if:
A Fast Ethernet Module fails, all of the Link
•
and Duplex LEDs blink simultaneously.
• The master SCM in slot 1 detects a module
failure, its Status LED is green and blinks
slowly.
The master SCM in slot 1 fails, the CSS does
•
not boot unless there is a passive SCM in
slot 2.
Disk activity
5.
If an error occurs during a power-on self-test, the console displays an error
message, increments the detected error counter, and continues to the next test until
the CSS completes all of the power-on self tests. See
Troubleshooting the Boot
messages.
After the CSS completes the boot process, it displays the login banner, copyright,
and login prompt.
When a startup-config file is present, the CSS displays the message:
CTRL-C to abort running the startup-config
Process, for more information on boot errors and
Cisco Content Services Switch Getting Started Guide
Logging in to the CSS
LED Color LED State
Green Solid
Red Blinking
Green Variable
blinking
Appendix A,
Press
1-9