Cisco CSS 11501 - Content Services Switch Getting Started Manual page 52

Initial Setup Quick Start
Table 2-1
Task and Command Example
10.
11.
12.
13.
The following running-configuration example shows the results of entering the
commands in
!*************************** GLOBAL ***************************
username picard des-password 1hbfoeqbyecclcac superuser
sntp server 192.168.19.21 version 2
sntp poll-interval 90
ip route 192.168.0.0 255.255.0.0 192.168.1.1 1
Cisco Content Services Switch Getting Started Guide
2-4
Initial Setup Quick Start (continued)
Configure the time using the clock time command. The clock time
command does not allow backspacing. If you enter the wrong time, reenter
the command with the new information.
Enter the time in the format hh:mm:ss.
# clock time
Enter time: [15:17:33] 16:17:33
(Optional) Specify the time zone and Universal Time Coordinated (UTC)
offset if you are using an SNTP server to synchronize the CSS system clock.
# clock timezone EST hours 3 before-UTC
(Optional) Access config mode and specify the SNTP server and the polling
frequency if you are using an SNTP server to synchronize the CSS system
clock.
# config
(config)# sntp server 192.168.19.21 version 2
(config)# sntp poll-interval 90
Save your configuration changes to the running-config file (recommended).
If you do not save changes to the running-config file, all configuration
changes are lost upon reboot.
(config)# exit
# copy running-config startup-config
Table 2-1.
Chapter 2 Configuring CSS Basics
OL-6037-01