Cisco CSS 11501 - Content Services Switch Getting Started Manual page 131

Troubleshooting the Boot Process
There are three phases in the boot process during which the Cisco 11500 series
CSS runs power-on self tests on the hardware and checks the boot configuration.
During any of these phases, the CSS reports problems through error messages.
•
•
This appendix contains the following major sections:
•
•
•
•
If the suggestions in this appendix do not help to resolve your booting problem,
contact the Cisco Technical Assistance Center (TAC).
For details about powering on and booting the CSS, including the various boot
states and the Status LEDs, refer to
Started.
OL-6037-01
With the CSS 11501, the internal motherboard boots all components in the
chassis and verifies that each component is properly functioning.
With the CSS 11503 and CSS 11506, the SCM boots each module in the
chassis and verifies that the module is functioning properly.
Diagnostic Tests for Hardware and Error Messages
Offline DM Verification of the Boot Configuration Record and Disk
CSS 11501 Boot and Verification
CSS 11503 and CSS 11506 Boot and Module Verification
A P P E N D I X
Chapter 1, Booting, Logging In, and Getting
Cisco Content Services Switch Getting Started Guide
A
A-1