Configuring The Ethernet Management Port - Cisco CSS 11501 - Content Services Switch Getting Started Manual

Booting the CSS for the First Time
Note

Configuring the Ethernet Management Port

Cisco Content Services Switch Getting Started Guide
1-4
After you receive the software license key, use the license command to enter the
license key. At the prompt, enter the license key. To install the Enhanced feature
set license key:
Log in to the CSS and enter the license command.
1.
# license
Enter the 12-digit Enhanced feature set software license key. For example:
2.
Enter the Software License Key (q to quit): nnnnnnnnnnnn
The Enhanced feature set license key is now properly installed and the feature set
is activated.
After you enter the software license key for the Proximity Database software
option, you must reboot the CSS for the license key to take effect.
Once you enter a valid license key at the boot prompt, the CSS displays the
following message and prompt:
Use the Ethernet management port IP address to access the Content
Services Switch for configuration and management only. This port does
not route traffic and is not associated with VLAN circuits.
The current address setting (0.0.0.0) disables the Ethernet Management
port.
Do you wish to configure a valid address for the Ethernet management
port [y/n]?
Chapter 1 Booting, Logging In, and Getting Started
OL-6037-01