Cisco CSS 11501 - Content Services Switch Getting Started Manual page 27

Chapter 1 Booting, Logging In, and Getting Started
Changing the Default Username and Password
OL-6037-01
Enter one of the following:
y to configure an IP address, subnet mask, and default gateway for the
•
Ethernet management port. The CSS prompts you for an IP address, a subnet
mask, then a default gateway. You must enter a valid IP address or the CSS
repeats the prompt until you do.
Enter IP Address [0.0.0.0]:
Enter Subnet Mask [0.0.0.0]:
Enter Default Gateway [0.0.0.0]:
The Ethernet management port IP address must be on a different subnet
Note
from any other CSS VLAN circuit subnet. If you do not make this IP
address unique, you will not be able to access the port.
n to accept the default IP address (0.0.0.0), subnet mask (0.0.0.0), and
•
gateway (0.0.0.0) and to disable the port. The CSS does not prompt you for
an IP address, subnet mask, and default gateway.
The Ethernet management port default IP address of 0.0.0.0 disables the Ethernet
management port. To enable the Ethernet management port, specify the ip
address command in boot mode (see
the Offline DM menu (refer to the Cisco Content Services Switch Administration
Guide).
The CSS allows you to change the default username and password. We
recommend that you change them to safeguard the CSS against unauthorized
logins.
Access to this device is allowed using the default username and
password. For enhanced security we recommend that you change the
defaults. Do you want to change the defaults now (yes,no):
Enter one of the following:
yes to change the username and password. The CSS prompts you for the
•
following information and password confirmation.
Enter <administrator> username:
Enter <administrator> password:
Confirm <administrator> password:
no to keep the default username and password.
•
Chapter 2, Configuring CSS
Cisco Content Services Switch Getting Started Guide
Booting the CSS for the First Time
Basics) or use
1-5